Seat covers fit the ends should fit without sagging. Although it takes very few to follow the instructions, the installation process is very important. There are some important tips to follow when you try to install seat covers car, when the installation method depends on the type and style of seat covers have.
In the case of universal seats, first remove the headrests and seat cover over top of the seat and pull down onSeat. Then establish good on the seat upholstery. Then fit the cover just above the seat base. Later, attach elastic under seat with supplied "S" hooks. Finally, tie the cable supplied can ensure that the seat cover is held in proper form. Check the seat cover is perfectly fitting the seat. After all processes are completed, re-install the headrest.
Installing custom seat covers will require more steps than any other car seat covers. First, remove allGuards or shields to prevent the original material, the installation of the seat cover. Install the bottom cover first place. Tie three strings provided cover flap and attach to the networks sit on the limb and secure it under the seat, springs, or another cycle on the covering of the seat opposite. Situated next to the seat back cover of the back straps or belt loop on the back seat cover. Then feed the strings or straps between the bottom and rear of the seat andsecure with appropriate rings on the top or sides of seat covers. Make sure that seat covers are fitting correctly. Then make small holes in the upholstery of the seat and headrest to accommodate hardware. After all processes are finished, re headrests and hardware.
0 comments:
Post a Comment